SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 732

21. Holding the cylinder horizontal, install the sleeve and
clutch plate assembly into the cylinder, with the crest
of one wave of the washer in line with one of the holes in
the outside of the cylinder, until the sleeve contacts the
C2 wave washer.
22. Check the C4 clutch pack clearance using 0555-336260
clutch pack clearance kit.
Notice
With the C2 wave spring compressed, and the clutch
Pack supporting a 2 kg weight, the dimension from
the underside of the C2 pressure plate to the selective
steel is to be between 1.4 ~ 1.8 mm. If the clutch is to
be gauged from the top of the pressure plate, then
the dimension is to be the actual thickness of the
pressure plate plus 1.4 ~ 1.8 mm.
23. Use selective plates to achieve the correct specification.
If new friction plates are being fitted, remove the clutch
pack and soak the friction plates in ATF for a minimum
of 5 minutes prior to reassembly.
Notice
The clutch pack clearance must be taken before the
elements are soaked in ATF.
24. Reassemble the sleeve and clutch pack into the
cylinder. Observe the alignment of the wave washer to
the hole in the cylinder.
25. Install the C2 clutch plates in the cylinder in the following
sequence:
• Friction disc
• Steel plate
• Friction disc
• Steel plate
• Steel plate (0574-000013, `014, `015, `016, `019,
`022), or Friction disc (0574-000012 & `017)
• Steel plate (selective)
• Friction disc
• Steel plate (selective)
• Friction disc
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
3A2-183
Y220_3A20J0
Y220_3A20K0
Y220_3A20L0
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN