Repairing The Tailgate Defogger Grid Line - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

9H-10
Voltage is changed around open circuit
Voltage
When checking at (-) terminal side
(No damaged grid line)
(Damaged grid area)
Center point
(+) Terminal
Measured value on "B" shows
doubled value on "A"
Masking tape
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
4) Move the test leads around suspected area to check
the circuit for open. The broken point shows the
voltage changes.
(-) Terminal
Y220_09H376
2. Turn the defogger switch "OFF" and check as follows.
Measure the resistance between the terminals and center
grid line. The broken point shows doubled resistance
value for other points. And, the damaged point shows
sharp voltage changes.
(-) Terminal
Y220_09H377
Repairing the Tailgate defogger
Grid Line
Preparations:
1) Conductible paint
2) Thinner
3) Masking tape and decal etc.
4) Alcohol
5) Thin brush
Clean around the damaged area and attach the masking
tape along the grid line as shown in figure. Clean the
Y220_09H378 area with alcohol. Apply the conductible paint with thinner
on the area 3 times with 15 minutes of interval. Remove
the masking tape before supplying the power. If required,
remove the excessive paint with a knife after completely
dried.
Notice
Clean the glass with dampened cloth after repair.
WIPER & WIPER MOTOR/HORN
REXTON SM - 2004.4