SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 735

3A2-186
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
11. Assemble the clutch plates and discs into the cylinder
in the following sequence :
• Steel plate
• Friction disc
• Steel plate
• Steel plate (0574-000013, `014, `015, `016, `019,
`022), or Friction disc (0574-000012, `017)
• Steel plate (selective)
• Friction disc
• Steel plate (selective)
• Friction disc
Y220_3A20R0
12. Align and fit the pressure plate with the counterbore facing
away from the clutch plates.
13. Install the circlip.
14. Check the C3 clutch clearance using 0555-336260 clutch
pack clearance kit in the following manner (weight only).
a. Place the weight on the pressure plate and measure
the distance from the end of the cylinder to the top of
the pressure plate.
b. Record this figure.
c. Remove the weight.
d. Lift the pressure plate up against the circlip and
measure the distance from the end of the cylinder to
the top of the pressure plate.
Y220_3A20S0
e. Record this figure.
f. Subtract the second reading from the first reading to
obtain the clutch pack clearance.
Notice
With the clutch pack supporting a weight of 2kg, the
clearance between the snap ring and the top of the
pressure plate is to be between 1.07 ~ 1.45 mm.
15. If new friction plates are being fitted, remove the clutch
pack and soak the friction elements in auto-matic
transmission fluid for a minimum of five min-utes prior to
reassembly.
Notice
The clutch pack clearance must be taken before the
Y220_3A20TA
elements are soaked in automatic transmission fluid.
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4