Oil Level Check; Oil Change - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

OIL LEVEL CHECK

The power steering oil level have to be checked by two
conditions; one is checked at normal operating temperature,
and the other one is checked when it is cooled. If the differ-
ence between two measurements is below 5 mm and the level
is between Max and Min level, it's normal. If it is over 5 mm,
bleed air from the system.
1. Place the vehicle on a flat ground and start the engine
and let it run at idle speed.
2. Turn the steering wheel several times so that the oil
temperature reaches to normal operating level.
3. Place the steering wheel at straight ahead direction.
4. Measure the oil level in the power steering oil reservoir.
5. Adjust the oil level between Max and Min.

OIL CHANGE

1. Lift up the vehicle very carefully.
2. Disconnect the oil supply hose from the power steering
pump.
3. Drain the oil from the power steering oil reservoir.
4. Connect the oil supply hose to the power steering pump.
5. Disconnect the oil return line from the power steering oil
reservoir.
6. Remove the high tension cables from the ignition coils.
7. Periodically crank the starting motor and turn the steering
wheel to its both ends to drain the oil in the reservoir
through the return line.
8. Connect the return line to the steering oil reservoir.
9. Fill the oil into the steering oil reservoir to the specified
level.
10. Bleed the air from the system.
POWER STEERING
REXTON SM - 2004.4
H. MAX - when the oil is hot
C. Leverage value - when the oil is cooled
ADD. MIN
Note
Always keep the oil level over the ADD line.
6C-25
Y220_06C051
Y220_06C052
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN