Transfer Fuel System Test; Test Procedures - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

4-2. Transfer Fuel System Test

Test Procedures

1. All wiring harnesses, connectors and fuel lines should
be installed properly and the engine should be ready to
start.
2. Prepare the special tools for transfer fuel system test
and thoroughly clean the system.
3. Disconnect the key connector for connecting the priming pump to fuel filter and install both connectors of the
special tool to the fuel pump and the priming pump hoses.
4. Start the engine and visually check the transfer line for clogged and air bubbles while running the engine at idle
speed.
5. If the fuel flows are not smooth or air bubbles are found in fuel lines, locate the leaking area and correct it.
DIAGNOSIS
DI ENG SM - 2004.4
DI10-187
Y220_10073
Y220_10074
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN