SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 1459

Too Much Heat
Check
Mode Is there too much heat
switch to when the mode switch is
the floor in the floor position?
position
Is the airflow proper?
Is the heavy airflow?
Does the airflow change?
Is the airflow proper?
Can you hear the sound
of the temperature door
slam?
HEATER & VENTILATION SYSTEM
REXTON SM - 2004.4
Yes Set the temperature control switch to defrost position.
No Set the mode switch to the vent position.
Yes Set the blower speed to 4th.
Set the temperature control switch to full hot.
Turn the ignition "ON".
Check the airflow and attachment at the foolr outlet.
No Check the door travel, the cables, the controls and the linkage
for the defrost position and then repair or replace as needed.
Yes Check the door travel, the cables, the controls and the linkage
for the full hot, full cold position and then adjust as needed.
No Check for a change in the airflow at different blower speed.
Check the change.
Yes System OK
No Go to "Blower Electrical"
Yes Turn the ignition "OFF".
Turn the temperature control knob to full hot, then rapidly to full
cold.
No Check the system case for leaks and check the floor outlet
attachment.
Yes Adjust the vent door to vent mode.
No Check the door travel, the cables, the controls and the linkage
for the full hot, full cold position and then adjust as needed.
Action
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
10B-21