Inspection Before Installation - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

Inspection Before Installation

Check the components for wear and damage before installation.
1. Check the release bearing for abnormal wear and replace
if needed.
2. Check the conditions of pressure plate.
Notice
Check each component and replace if needed.
3. Check the alignment of clutch housing.
1) Set the pressure plate at the housing bore.
2) How to align the housing bore
- Install a dial gauge on the magnetic plate.
- Measure and record the gauge needle while
rotating the crankshaft for one revolution.
3) How to align the housing surface
- Install a dial gauge on the housing surface.
- Measure and record the gauge needle while
rotating the crankshaft for one revolution.
Notice
If the measured value is greater than 0.010 inch, align
it by inserting shims between housing and clutch.
4. Check the following components:
• Pressure plate assembly
• Disc
• Flywheel
Notice
Replace the excessive worn components.
TSM54/52 MANUAL TRANSMISSION
REXTON SM - 2004.4
3B-35
Y220_03B050
Y220_03B053
Y220_03B054
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN