SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 957

4A-22
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Assembly
1. Clean all parts and check the followings:
• Check the ring gear, drive pinion for wear and damage.
If damaged, replace it as a set.
• Check the bearing for sticks, wear, noise and turning
resistance.
• Check the side gear, pinion, pinion shaft and thrust
washer for wear and damage.
• Check the differential carrier for crack and wear
(bearing sliding surface). Check the gear case for
Y220_04A051 crack.
2. Insert the drive pinion assembly into the axle housing
and tighten the pinion lock nut (1).
Tightening torque
Y220_04A052
3. Assemble the differential carrier assembly. At this time,
align the ring gear to the mark on the differential carrier
and tighten the bolts (2).
Tightening torque
4. Measure the backlash between side gear and pinion gear.
Specified value
Y220_04A053
5. Install the differential carrier assembly into the axle
housing. Install the bearing cap.
Tightening torque
Notice
Be careful not to mix the caps.
Y220_04A054
240 ~ 310 Nm
75 ~ 90 Nm
0 ~ 0.5 mm
48 ~ 69 Nm
FRONT AXLE
REXTON SM - 2004.4