Front And Rear Band Adjustment; Front Band Setting Procedure - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

FRONT AND REAR BAND ADJUSTMENT

Front Band Setting Procedure

1. Measure the projection of the front servo push rod
from the transmission case dimension 'A'.
a. Apply air at 650/700 kPa to the front servo apply
area (B1 outer)
b. Measure the travel of the push rod and subtract 3
mm to find the shim size required.
c. Release the air.
Thickness(mm)
0.95/1.05
1.15/1.25
1.44/1.56
1.73/1.87
1.93/2.07
2.12/2.28
2.42/2.58
2.61/2.79
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
Notice
A minimum of one shim is required at all times -
minimum shim size is 1 mm. The thickness of available
shims are listed in the table below.
Part Number
0574-037017
0574-037018
0574-037019
0574-037020
0574-037021
0574-037022
0574-037023
0574-037024
2. Fit the selected shim(s) to the shank of the anchor
strut as follows:
a. Inspect the shim(s) for damage, wear or corro-
sion. Replace as necessary.
b. The shim(s) are to be installed between the case
abutment face and the anchor strut flange.
c. The shim(s) are to be fitted by hand and under no
circumstances to be hammered or forced.
d. Shim(s) are to be pressed on by hand until an
audible click is heard. The click indicates that
the shim is clipped home correctly.
3. Re-check that the push rod travel.
(3mm ± 0.25mm)
3A2-201
Y220_3A22E0
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN