Front Axle Shaft (For Part Time T/C) Installation - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

4A-10
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Installation
Clean all the removed elements. Check O-ring and snap ring
for wear and damage. Replace the defective elements with
new ones.
1. Install the axle shaft to axle housing. Make sure to
securely seat the axle shaft onto the housing.
Notice
Be careful not to damage the boots during installation.
2. Securely connect the steering knuckle and axle shaft.
3. Install the steering knuckle to the upper arm and lower
arm and lock them with split pins.
Tightening torque
(Lower arm, 1)
Tightening torque
(Upper arm, 2)
Y220_04A017
4. Install the dust shield to knuckle.
Y220_04A018
5. With full time transfer case only
1) Install the hub assembly to axle shaft and tighten
the hexagon nut with Loctite applied (blue).
Tightening torque
Notice
Replace it with new one.
Y220_04A019
140 ~ 160 Nm
140 ~ 160 Nm
100 ~ 130 Nm
FRONT AXLE
REXTON SM - 2004.4