C3 Clutch Cylinder - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

3A2-168
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
9. Invert the clutch cylinder and remove the C4 clutch sleeve,
clutch plates and the two wave washers. The 3-4 one
way clutch is located between the C2 and C4 clutch
hubs, and the hubs may be separated by rotating one
hub clockwise and withdrawing it from the other.
10. Remove the thrust block from the C4 clutch cylinder hub.
Y220_3A2680
11. Mount the clutch cylinder on clutch spring compressor
0555-336259 with the C2/C4 end uppermost and
compress the piston return spring. Remove the spring
retaining circlip. Release the tool and remove the circlip,
keeper and spring.
Notice
Make sure that the spring keeper is not caught in the
circlip groove, and that all the spring pressure is
released, before removing the tool.
12. Invert the clutch cylinder on the compressor tool and
removethe C1 clutch piston return spring in asimilar
manner.
Y220_3A2690
13. To remove the clutch pistons from the clutch cylinder,
apply air pressure to the apply ports in the bore of the
cylinder.
Y220_3A2700

C3 Clutch Cylinder

Tools Required
0555-336259 Clutch Spring Compressor
1. Remove the forward sun gear, No.7 needle bearing (2)
thrust washer (1) and lipped thrust washer (3) from the
C3 clutch cylinder.
2. Remove the thrust plate (4), No.6 needle bearing (5),
thrust plate (6) and nylon thrust plate (7) from the clutch
cylinder hub.
3. Remove the clutch plate retaining circlip and re-move
the clutch plates.
Y220_3A2720
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4