Torque Converter And Housing Assembly; Output Flange Assembly (2Wd Mode) - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

3A2-200
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
6. Fit the oil pan assembly to the transmission case and
tighten the securing bolts to specification and sequence
Do not over torque.
Installation Notice
Tightening torque
Y220_3A22C0
Torque Converter and Housing
Assembly
1. Locate the torque converter housing on the trans-mission
main case.
2. Apply additional Loctite 202 or equivalent as required to
the converter housing to case bolts. Install and tighten
bolts to specification.
Installation Notice
Tightening torque
Y220_3A22D0
• All the hardware must be correctly installed and
torqued to specification.
3. Fit the converter ensuring that the tangs are engaged in
the pump gear. Ensure that the tangs do not contact the
pump seal.

Output Flange Assembly (2WD Mode)

1. Position the transmission detent lever into the park
position and lock the output shaft.
2. Clear the threads on the output shaft and apply Loctite
243 or equivalent as required to threads.
3. Install the flange, "O" ring and torque the nut to
specification.
Installation Notice
Tightening torque
KAC5A040
Y220_3A2040
4 ~ 6 Nm (35 ~ 53 lb-in)
54 ~ 68 Nm (40 ~ 50 lb-ft)
35 Nm (26 lb-ft)
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4