SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 1250

9A-4
Test probe
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Y220_09A004
Y220_09A005
Test probe
Connecter
Y220_09A006
7. Loosened connection may cause a malfunction. Always
firmly engage the connector.
8. When connecting, push the connector until it sounds
"click".
9. When disconnecting, always hold the connector body
other than the harness.
10. Disconnect the connector while pressing down the locking
tab if applicable.
11. When checking the continuity or voltage, the test probes
of the circuit tester should be inserted from harness side
(rear of connector). In case of sealed connector, insert
the test probe through the cavity in wiring rubber cap. Be
careful not to damage the wire insulation. And, the test
probe should be insert until its end contacts to the
connecter pin.
Notice
The circuit tester cannot be used for checking the air
bag system. Use only the diagnostic tool (Scanner).
GENERAL
REXTON SM - 2004.4