SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 908

3E-12
Section Pin No.
17, 18
Power
supply
4, 19
Input side 5
27
10
28
30
9
11
29
25
Both sides 22
23
20
Output side 16
1, 14
2, 15
3
6
13
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Name
Ground
B+
Ignition switch
Position 1
Position 2
Position 3
Position 4
4H and 4L switch
Front speed sensor
Rear speed sensor
ABS operation
CAN HIGH
CAN LOW
K - LINE
Speed sensor voltage
Motor HI-LO
Motor LO-HI
EMC
Speed return
Speed return
Description
TOD control unit ground
TOD control unit battery voltage input
Ignition switch power
: ON - over 4 V, OFF - below 0.9 V
Position encoder – shift motor position recognition
HIGH - over 4 V, LOW - below 0. 9 V
Same as above
Same as above
Same as above
Mode input according to 4H and 4L selection
: HIGH - over 4 V, LOW - below 0.9 V
Front speed sensor (hall effect) signal input
Rear speed sensor (hall effect) signal input
ABS operating signal input (ABS ON/OFF)
Operation - over 4 V, Not operation - below 0.9 V
(NON CAN ABS model)
CAN bus HIGH line
CAN bus LOW line
Connected to trouble diagnosis connector
Supplying 5V to front/rear speed sensors
Motor output port
- Connected to battery when shifting to LO from HI
- Connected to ground when shifting to HI from LO or
braking the motor
Motor output port
- Connected to battery when shifting to HI from LO
- Connected to ground when shifting to LO from HI or
braking the motor
Supplying the voltage to clutch coil
- Frequency: 50 Hz, - Duty ratio: 0 ~ 88 %
Providing the ground to position encoder
Providing the ground to speed sensor
TOD
REXTON SM - 2004.4