SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 987

Assembly
1. Clean all parts and check the followings:
• Check the ring gear, drive pinion for wear and damage.
If damaged, replace it as a set.
• Check the bearing for sticks, wear, noise and turning
resistance.
• Check the side gear, pinion, pinion shaft and thrust
washer for wear and damage.
• Check the differential carrier for crack and wear
(bearing sliding surface). Check the gear case for
crack.
2. Insert the drive pinion assembly into the axle housing
and tighten the pinion lock nut.
Tightening torque
3. Assemble the differential carrier assembly. At this time,
align the ring gear to the mark on the differential carrier
and tighten the bolts.
Tightening torque
4. Measure the backlash between side gear and pinion gear.
Specified value
REAR AXLE
REXTON SM - 2004.4
240 ~ 310 Nm
75 ~ 90 Nm
0 ~ 0.05 mm
4B-23
Y220_04B055
Y220_04B056
Y220_04B057
Y220_04B058
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN