SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 724

11. Poition the manual valve detent lever, aligning it with the
cross-shaft bore in the case.
12. Push the shaft through the detent lever until it starts in
the detent lever side of the case.
13. Install the detent lever drive pin in the shaft using cross
shaft pin remover/installer (detent lever) 0555-336258 with
the adaptor over the pin.
14. Press the pin into the shaft until the tool bottoms.
15. Remove the tool and fit the spring retaining circlip to the
shaft.
16. Install the new cross shaft seals using cross shaft seal
installer 0555-336262 (1) and cross shaft bullet 0555-
336263 (2).
17. Install the inhibitor switch on the case. Torque the bolts
as per specifications. Press the pin into the shaft until
the tool bottoms using cross shaft pin installer/remover
(inhibitor switch) 0555-336265.
Installation Notice
Tightening torque
18. Thoroughly check the terminal wiring loom for condition
and continuity.
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
4 ~ 6 Nm (35 ~ 53 lb-in)
3A2-175
Y220_3A2920
Y220_3A2600
Y220_3A2930
Y220_3A2580
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN