SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 1460

10B-22
Heater Controls
Check
Turn the Is excessive effort required
temperature to move the control?
control
switch
Does the control operate
properly?
Is there any door binding?
Does the control bind?
Does the control bind?
Is excessive effort
required to move the
control?
Does the control operate
properly without any
interference?
Is the installation good
condition?
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Yes Check the cable for improper routing, kinks, wiring interference
or other instrument panel interference.
No Set the blower switch to 4th.
Repeat to turn the temperature control knob to full hot, then
rapidly to full cold
Yes Remove the cable from any door that binds on the cable.
Cycle the door manually.
Check the door binding.
No Repair or replace the problem.
Yes Check the door seal for proper installation.
No Check the control for binding.
Yes Reinstall the cable to the door.
Repair the instrument panel interference with the cable.
No Remove the cable from the control.
Check the control for binding.
Yes Replace the control switch.
No Replace the cable.
Yes Remove the cable from the control.
Operate the control switch.
No System OK
Yes System OK
No Replace the control switch.
Yes Check a binding door for the shaft alignment, a bent shaft, a
bent door or warped case and then repair as needed.
No Repair the door seal or replace as needed.
Action
HEATER & VENTILATION SYSTEM
REXTON SM - 2004.4