SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 1154

8C-10
Inspection
1. Clean the dissembled components and visually check the followings:
• Wear, rust and damage on the cylinder and piston
• Damage, crack and wear on cylinder body and guide pin
• Uneven wear and oil contamination on boot
• Damage and tear on boot
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
A
Y220_08C016
Y220_08C017
2. Measure the pad thickness.
New pad thickness
10 mm
Notice
If any of pads is below the wear limit, replace both
pads at a time.
3. Measure the disc thickness.
New pad thickness
10.4 mm
4. Check the disc plate for scratch and bend.
Wear limit
2 mm
Wear limit
8.5 mm
REAR BRAKE
REXTON SM - 2004.4