SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 746

16. Install the reverse lockout valve, spring, plug and retaining
plate. Ensure that the valve is correctly oriented.
17. Position the five nylon ball checks in the upper valve body.
18. Fit the upper valve body gasket. Install the separa-tor
plate over the upper valve body.
19. Holding the separator plate to the upper valve body to
prevent the check balls from falling out, install the upper
valve body on the lower valve body. Install all screws
finger tight then tighten the screws to specification in
the prescribed sequence.
Installation Notice
Tightening torque
20. Install solenoids 1, 2, 3, 4 and 6. Ensure the solenoid is
firmly secured by the retainer and that the screw is
tightened to specification.
Installation Notice
Tightening torque
• The wiring loom ground wire eyelet terminal is secured
beneath the solenoid 1 retainer.
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
11 ~ 16 Nm (8 ~ 12 lb-ft)
8 ~ 12 Nm (71 ~ 106 lb-in)
3A2-197
Y220_3A21V0
Y220_3A2840
Y220_3A2830
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN