SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 719

7. Depress the plug inward and remove the retaining pin for
each of the three valves.
Notice
Some of the valves and plugs are preloaded by
springs and may unexpectedly fall out of the cover
when the pins are removed.
8. Remove the four valves, plugs and springs.
9. Remove the pump gears from the pump body.
10. Remove the lip seal from the front of the pump body.
Valve Body
1. Remove the manual valve detent spring and retainer
plate using a T40 Torx bit.
2. Slide the manual valve out of the lower valve body.
Notice
Be aware that the manual valve will fall out of the
valve body.
3. Take note of the angular relationship of the solenoid
terminals to the valve body and remove the solenoids 1,
2, 3, 4, 5, 6 and valve assemblies.
Notice
Take care that the bracket is not separated from the
solenoid.
4. Place the valve body assembly on the bench with the
upper body uppermost.
5. Remove the 24 clamping screws with a No. 30 Torx bit.
Separate the upper and lower valve bodies by lifting the
upper body and the separator plate together.
6. Turn the upper body over and place it on the bench with
the separator plate uppermost.
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
3A2-171
Y220_3A2800
Y220_3A2810
Y220_3A2820
Y220_3A2830
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN