SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 935

8. Remove the tapings in both sides of protective tube.
9. Remove the tube.
10. Hold the "L" pin in speed sensor connector with long
nose pliers and push it rearward to disconnect from the
connector.
11. Disconnect the "M" and "N" pin and wire from the
connector with same manner.
Notice
EMC wire cannot be disconnected from outside,
therefore do not try to disconnect it.
12. Get a new speed sensor.
13. Insert three pins and wires into each location from rear
side of the connector.
14. Hold each pin with long nose pliers and pull it to securely
install in the connector.
15. Insert each rubber cap into the connector to prevent the
pins from disconnecting.
16. Insert the protective tube for connector into the harness.
17. Bind both ends of the protective tube with tape.
18. Install the rear speed sensor into the mounting hall and
press both ends of it to be securely seated.
19. Tighten the bolts.
Installation Notice
Tightening torque
20. Install the speed sensor connector. Insert the connector
into the locking sleeve.
Notice
Remove the shift motor first before removing the front
propeller shaft speed sensor. When replacing the
sensor assembly after removing the shift motor, use
the same manner for removal of rear speed sensor.
TOD
REXTON SM - 2004.4
3 ~ 6 Nm
3E-39
Y220_03E033
Y220_03E034
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN