SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 872

Section Pin No.
Power supply 12, 25
13, 26
23
Input side
18
5
19
17
4, 16
7
Both sides
8
9
21
Output side 10
1, 14
2, 15
11
20
3
24
PART TIME
REXTON SM - 2004.4
Name
Ground
B+
Ignition switch
Position 1
Position 2
Position 3
Position 4
2H, 4H, 4L switch
Rear speed sensor
CAN HIGH
CAN LOW
K - LINE
Speed sensor voltage
Motor HI-LO
Motor LO-HI
EMC
Position ground (return)
Speed ground (return)
Hub solenoid
Description
Part time TCCU ground
Part time TCCU battery voltage input
Ignition switch voltage
: ON - above 4V, OFF - below 0.9 V
Position encoder : recognize shift motor position
HIGH - above 4 V, LOW - below 0.9 V
Same a above
Same a above
Same a above
Mode input by 2H, 4H, 4L selection
: HIGH - above 4V, LOW - below 0.9 V
Rear speed sensor (Hall effect) signal input
CAN bus HIGH line
CAN bus LOW line
Connected to diagnosis connector
Supply 5V to front and rear speed sensors
Motor output port
- Connected to battery when shifting to LO from HI
- Connected to ground when shifting to HI from LO or
when braking the motor
Motor output port
- Connected to battery when shifting to HI from LO
- Connected to ground when shifting to LO from HI
or when braking the motor
Supply voltage to clutch coil
- Max. current: 9 A
Provide ground to position encoder
Provide ground to speed sensor
Supply voltage to hub solenoid
3D-11
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN