Rear Band Setting Procedure - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

3A2-202

Rear Band Setting Procedure

1. Measure distance "A" from the rear servo piston to
the inner face of the transmission case using vernier
calipers.
a. Apply air at 650/700 kPa to the rear servo apply
area (B2 outer)
b. Measure the travel of the piston, subtract 3.75
mm and divide the remainder by 2.5 to find shim
size.
c. Release the air.
Thickness(mm)
0.0.95/1.05
1.15/1.25
1.44/1.56
1.73/1.87
1.93/2.07
2.12/2.28
2.42/2.58
2.61/2.79
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Notice
A minimum of one shim is required at all times -
minimum shim size is 1 mm. The thickness of available
shims are listed in the table below.
Part Number
0574-037017
0574-037018
0574-037019
0574-037020
0574-037021
0574-037022
0574-037023
0574-037024
2. Fit the selected shim(s) to the shank of the anchor
strut as follows.
a. Inspect the shim(s) for damage, wear or corrosion
and replace as necessary. The shim(s) are to be
installed between the case abutment face and
the anchor strut flange.
b. The shim(s) are to be fitted by hand and under no
circumstances to be hammered or forced
c. The shim(s) are to be pressed on by hand until
an audible click is heard. The click indicates that
the shim is clipped home correctly.
3. Re-check that the piston travel.
(3.75 mm ± 0.625 mm)
Y220_3A22F0
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4