SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 1405

9H-12
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
9. Heat the repair area for 1 to 2 minutes.
Notice
The grid line repair material must be cured with heat
heat. In order to avoid heat damage to the interior
trim, protect the trim near the repair area where heat
will be applied.
10. Hold the heat gun nozzle 25 mm from the surface. A
minimum temperature of 149°C is required.
Y220_09H383
11. Inspect the grid line repair area. If the repair appears
discolored, apply a coating of tincture of iodine to the area
using a pipe cleaner or a line brush. Allow the iodine to
dry for about 30 seconds. Carefully wipe off the excess
iodine with a lint-free cloth.
12. Test the operation of the tailgate defogger in order to
verify that the repair was successful.
Notice
At least 24 hours is required for complete curing of
the repair materials. The repair area should not be
physically disturbed until after that time.
Y220_09H384
Repairing the Braided Lead Wire
The tailgate defogger bus lead wire or the terminal can be
reattached by resoldering. Use a solder containing 30 percent
silver and a rosin flux paste.
1. The repair area should be buffed with fine steel wool before
soldering the bus lead wire.
2. Apply the paste-type rosin flux in small quantities to the
wire lead and the bus lead wire repair area using a brush.
3. Coat the soldering iron tip with solder. Use only enough
solder to ensure a complete repair.
Y220_09H385
4. Use only enough heat to melt the solder. Do not overheat
the wire when resoldering to the bus lead wire.
Y220_09H386
WIPER & WIPER MOTOR/HORN
REXTON SM - 2004.4