Bleeding Of Clutch System - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

3C-8
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN

BLEEDING OF CLUTCH SYSTEM

Notice
• Keep the fluid level over MAX in reservoir during
bleeding operation.
• Do not let the fluid contact a painted surface.
1. Remove the air bleed bolt cap on the release cylinder.
Connect a plastic tube to the bolt.
2. Put the other side of the tube into a empty container.
3. Slowly pump the clutch pedal several times.
4. With clutch pedal fully depressed, open the air bleed bolt
and bleed the air and fluid from the fluid line.
Y220_03C006
5. Repeat step 3 through 4 until no more air bubbles are in
the escaping fluid.
Note
5mm
• This work has to be done by two service persons.
• After bleeding, check the clutch system for
operation and noise.
• Use only Ssangyong genuine clutch fluid, and check
the clutch fluid level in reservoir.
Clutch fluid
Y220_03C007
SAE J1730 or DOT 3, 4
CLUTCH
REXTON SM - 2004.4