SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 727

3A2-178
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Planet Carrier Assembly and Centre
Support
1. Check the carrier and planet assembly for any damage
or irregularity and ensure that all pinions rotate freely
and that the pinion end float is within 0.10 mm ~ 0.50
mm.
Y220_3A20A0
2. Install the One Way Clutch (OWC) retainer (1) to the
planet carrier with the inner edge pointing down-wards.
Inspect the OWC race and the sprag assemblies for wear
or damage. Replace if necessary.
3. Install the outer (3) race in the drum. Press the race to
the bottom of the drum and install the retaining circlip
(2). Ensure the circlip is firmly seated in its groove.
4. Install the OWC (1) into the outer race with the lip edge
uppermost. Lubricate the sprags with auto-matic
transmission fluid.
Y220_3A2760
5. Check that the plugs are fitted to the centre support,
then assemble the centre support into the OWC, ensuring
that the support will rotate in an anti-clock-wise direction
only.
6. Lubricate the No. 9 needle bearing and washer with
petroleum jelly and fit them to the rear face of the planet
carrier.
Y220_3A2750
7. Install the planet assembly and the centre support into
the case, and align the centre support mounting bolt
holes.
8. Install the centre support bolts finger tight.
9. Install the circlip retainer ensuring that the circlip is
completely seated in the groove of the case.
10. Remove the centre support bolts and apply Loctite 222
or equivalent to the threads. Install the bolts and torque
to specifications.
Installation Notice
Tightening torque
Y220_3A2560
20 ~ 27 Nm (15 ~ 20 lb-ft)
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4