Transmission Case - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

15. Remove the two centre support retaining bolts using a
T50 Torx bit.
16. Remove the centre support retaining circlip.
Notice
Do not hammer the output shaft to remove the centre
support as this will cause permanent damage to the
thrust bearing surfaces.
17. Remove the centre support, 1-2 one way clutch, and
planetary gear set as an assembly.
18. Remove the parking rod cam plate using a T40 Torx bit.
19. Remove the rear band struts and remove the band.
Notice
Vise the both end of rear band using the plier and
lean forward about 15 degrees
20. Remove the output shaft assembly.

Transmission Case

Tools Required
0555-336258 Cross Shaft Pin Remover/Installer
(Detent Lever)
0555-336261 Cross Shaft Seal Remover
0555-336265 Cross Shaft Pin Remover/Installer
(Inhibitor Switch)
1. Remove the pin from the side of cross shaft inhibitor switch
using cross shaft pin remover/installer (inhibitor switch)
0555-336265.
2. Remove the inhibitor switch bolts and inhibitor switch
from the case.
3. Remove the cross shaft seals with cross shaft seal
remover 0555-336261.
4. Remove the circlip from the cross shaft. Pull the shaft to
release the drive pin from the selector quadrant.
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
3A2-165
Y220_3A2560
Y220_3A2570
Y220_3A2580
Y220_3A2590
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN