Front Band Assembly - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

3A2-180
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
7. Compress the servo cover and fit the servo cover retaining
circlip, aligning the gap with the pan rail, and ensuring
that it is completely seated in its groove.
Notice
Ensure that the front servo snap ring is installed
correctly. Orient the circlip with the gap at the
bottom, near the pan rail.
Y220_3A20D0

Front Band Assembly

1. Install the reaction anchor strut to the case.
2. Check the band for all cracks or damage along its lining
and metal backing.
3. Position the strut retainers on the band.
Y220_3A20E0
4. Install the front band into the transmission case, ensuring
that it is properly seated in place.
Notice
If fitting a new band, soak the band in automatic
transmission fluid for a minimum of 5 minutes prior
to assembly.
5. Position the reaction strut in its retaining clip and engage
it with the band and anchor strut.
6. Position the apply strut in its retaining clip and engage it
with the band and the servo piston rod.
Y220_3A2550
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4