Charging Refrigerant; Charging For Gas; Charging For Liquid - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

10C-18
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN

Charging Refrigerant

Charging for gas

Notice
This operation is for charging the gas refrigerant into
the charging valve through the low pressure side. At
this time, if the refrigerant tank is upright on a flat
floor, the gas refrigerant will flow into the charging
valve.
1. Connect the tap valve to the refrigerant tank.
Y220_10C025
2. Open the low pressure and adjust the low-side reading
below 4.2 kg/cm
3. Place the refrigerant tank in the warm water (40°C) and
keep the gas pressure in the refrigerant tank higher than
the gas pressure in the charging valve.
4. Run the engine at high speed and operate A/C system.
Notice
Place the refrigerant tank on the flat floor to protect
the liquid refrigerant from coming through the
suction inlet resulting in the compressor's damage.
5. Charge the specified amount to the charging valve and
Y220_10C026
close the low pressure valve.
Specified amount
Notice
• If the charging speed is low, it's more efficient to
place the refrigerant tank in the warm water
(40°C). But the temperature should keep below
(52°C) at any situation.
• Be careful not to contact the heating device or
material.

Charging for liquid

This operation is for charging the liquid refrigerant into the
empty system through the high pressure side. At this time, if
the refrigerant tank is upside down, the liquid refrigerant will
flow into the system.
Notice
• Do not operate when charging the system through the
high-side rpessure.
• Do not open the low pressure valve when charging the
system by the liquid refrigerant.
Y220_10C027
2 .
Single: 850 ± 50 g
Dual: 1200 ± 50 g
A/C SYSTEM
REXTON SM - 2004.4