SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 910

3E-14
If 4H/4L switch position is not matched with shift motor position code with the ignition switch "ON", the shift require-
ments operate to the direction of 4H/4L switch. However, the shifting requirements should be met to shift.
• Shifting requirements:
- The transmission is in neutral for 2 seconds after the shift is requested.
- Both propeller shaft speeds are below 43 Hz.
A command to shift will only be acted upon if the TOD is reading a valid code at the time the command to shift is made.
After a shift has started, the TOD will power the shift motor until the code for the requested position is read. If an invalid
code is read, the TOD will go into a default mode.
During a shift attempt, the shift motor will be energized for a maximum of 5 seconds.
In case of manual transmission, the clutch pedal should be depressed.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
TOD
REXTON SM - 2004.4