Trouble Code - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

10A-16

Trouble Code

Trouble
Trouble Description
Code
0 No faults
10 Shutdown for overvoltage
11 Shutdown for undervoltage
12 Overheating (software threshold)
14 Overheating (difference evaluation)
15 Overheating (operating block)
16 Difference evaluation 2
17 Overheating (hardware, device)
20 Glow plug interruption
21 Overload, short-circuit or ground
contact, glow plug output
22 Glow plug output defect
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
• Measure battery voltage (must be < 15.9 V)
• Check alternator
• Measure battery voltage (must be > 10.2 V under load)
• Check alternator
• Check lead
Temperature at overheating sensor >125°C
• Check cooling system:
• Check the temperature sensor and overheating sensor, replace
if necessary
Difference in temperature values between surface sensor and con-
trol overheating sensor is too large. (Prerequisite for this trouble
code display is that the heater is in operation and the water tem-
perature at the overheating sensor has reached min. 80°C)
• Check cooling system
• Check the temperature sensor and overheating sensor, replace
if necessary
The controller is locked.
• Delete the fault memory to release the controller
• Check cooling system
• Check the temperature sensor and overheating sensor, replace
if necessary
If the surface sensor has a far higher temperature value than the con-
trol overheating sensor, then the system proceeds with a fault shutdown.
Temperature at control overheating sensor > 125°C
• Check cooling system
• Check the temperature sensor and overheating sensor,replace
if necessary
• Check cable harness for this component for damage and
through current and replace component if necessary
• Check plug-in connection, replace component if necessary
• Check cable harness for this component for damage, replace
component if necessary
• Check cable harness for this component for damage, replace
component if necessary
Remedies
FFH/PTC SYSTEM
REXTON SM - 2004.4