Registration Of Receiver Code; Code Output Requirements - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

9B-28

3. Registration of receiver code

- Only one receiver code can be registered.
- The received code cannot be output during the registration.
- The hazard relay output is "ON" for T1 and the siren output is "ON" for T2 when registering the code.
• Code saving terminal: OFF ⇒ ON (applying battery voltage)
• Press the lock switch or the unlock switch on the transmitter.
CODE SAVING
DEVICE
SENDING SIGNAL
REGISTRATION
MODE
OPERATION MODE
HAZARD RELAY
SIREN

4. Code output requirements

- When the "customer" and "ID" codes are correct and the "rolling" code is within operating range while the
ignition switch is removed and the code saving device is turned off, the code can be output after identifying the
"function" code.
- The function codes that can be output are "LOCK" and "UNLOCK".
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
RECEIVE
NO SIGNAL
MODE
REGIS- DISRE- DISRE-
TERED GARDED GARDED
ONCE ONCE ONCE
Y220_09B076
ELECTRIC SYSTEM
REXTON SM - 2004.4