SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 571

Installation and Inspection
• Place the automatic transmission upright as shown in figure
and install the torque converter by rotating the torque
converter. When installing from sideway, the torque
converter sealing ring may be damaged by driving flange
which could cause oil leaks.
• Use special tools when removing and installing torque
converter.
Notice
Place the automatic transmission upright when
removing and installing torque converter.
If not, the oil seal may be damaged when servicing
the torque converter.
• The distance between the upper end of torque converter
and the mating surface of automatic transmission housing
should be within specified value as follows:
Specified installation height (A)
DC 5-SPEED AUTOMATIC TRANSMISSION
REXTON SM - 2004.4
below 6.5 mm
3A1-19
Y220_3A1015
Y220_3A1016
Y220_3A1017
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN