SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 1313

Oil Pressure Switch
1. Stop the engine and check the continuity between
terminal and ground.
2. Start the engine and check the continuity between
terminal and ground.
3. Disconnect the connectors from the warning switch in
wiring harness side and ground terminal.
4. Check if the warning light comes on when turning the
ignition switch to "ON" position. If it doesn't come on,
check the bulb and wiring harness.
Brake
The brake warning light comes on when the brake oil level goes below the specified level or the parking brake is applied
while the ignition switch is turned to "ON".
Note
The brake oil sensor is installed on the brake master cylinder reservoir.
1. Disconnect the oil level gauge connector.
2. Check the continuity between terminals when turning "OFF" the switch.
3. Check the continuity between terminals when turning "ON" the switch. If the continuity is out of specified standard,
replace the sensor.
INSTRUMENT PANEL AND MULTI-METER
REXTON SM - 2004.4
Ohmmeter
Ignition switch
Warning light
Battery
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
9C-17
Y220_09C244