Transmission Disassembly Procedure - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

DISASSEMBLY PROCEDURE
Transmission
Tools Required
0555-336256 Transmission Bench Cradle
0555-336257 Pump Puller
Notice
• Remove the inhibitor switch before washing the transmission in solvent or hot wash.
• It is assumed that the transmission fluid has been drained when the transmission was removed from the
vehicle and that the "special tools" quoted are available.
• The transmission is dismantled in a modular fashion, and the details of disassembly for each module are given
under the appropriate subject. Refer to Special Tools Table in this chapter for details of all special tools
required when performing disassembly procedures.
• Technicians overhauling these transmissions will also require a selection of good quality Torx bit sockets, in
particular numbers 30, 40 and 50, and an 8mm, 10mm and 12 mm double hex socket.
1. Remove the converter and the converter housing.
2. Mount the transmission on the transmission bench cradle
0555-336256.
3. Remove the oil pan and the oil pan seal.
4. Remove each end of the filter retaining clip from the valve
body and remove the filter.
5. Disconnect the wires from each solenoid and ground and
lay the wiring to one side.
6. Remove the valve body securing screws and remove the
valve body from the case.
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
3A2-163
Y220_3A2500
Y220_3A2510
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN