Rear Band Assembly; Rear Servo Assembly - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

Rear Band Assembly

1. Check the rear band for any cracks or damage along the
lining and metal backing.
2. Install the reaction anchor strut into the main case,
without shims.
3. Carefully install the rear band into the transmission case
and ensure that it is properly fitted in the case.
Notice
If fitting a new band, soak the new band in automatic
transmission fluid for a minimum of five minutes prior
to assembly.
4. Position the apply strut on the rear band then engage
the apply strut in the servo lever.
5. Install the cam plate and tighten the screws to
specification.
Installation Notice
Tightening torque

Rear Servo Assembly

1. Check the servo piston "O" rings and gasket for any
damage.
2. Lubricate the servo piston "O" rings with automatic
transmission fluid, and fit the "O" rings to the piston
grooves.
3. Assemble the piston to the cover, ensuring that "O" ring
compression is adequate but not excessive.
4. Align the spring on the piston spigot, then position the
rear servo rod into the spigot.
5. Assemble the gasket to the cover and fit the assem-bly
to the case.
Notice
Do not use petroleum jelly on the gasket.
6. Apply additional Loctite 202 or equivalent as required to
the rear servo to case bolts. Install the bolts and tighten
to specification.
Installation Notice
Tightening torque
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4
16 ~ 22 Nm (12 ~ 16 lb-ft)
30 ~ 35 Nm (22 ~ 26 lb-ft)
3A2-177
Y220_3A2950
Y220_3A2960
Y220_3A2630
Y220_3A2990
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN