Output Shaft And Gear Assembly - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

3A2-176
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
19. Position the wiring loom and locate the solenoid 7 contact
and terminal in the pump mounting flange at the front of
the case. The solenoid 7 wire is routed under the park
rod and cross shaft in the case.
Y220_3A2940
20. Install the 10 pin connector in the case engaging the
tangs on the connector in the notches in case.
Y220_3A2610

Output Shaft and Gear Assembly

1. Check that the output shaft bush is not worn or damaged.
Replace if necessary.
2. Check for damage to parking pawl teeth on the ring gear.
Replace if necessary.
3. Check that the sealing ring grooves have not been
damaged.
4. Lubricate the sealing rings with automatic transmission
fluid.
5. Assemble the sealing rings to the output shaft with the
Y220_3A2970
scarf cut uppermost.
6. If previously dismantled, assemble the ring gear to the
output shaft and secure with circlip. Ensure that the circlip
is firmly seated in its groove.
7. Install the No. 10 needle bearing assembly onto the
output shaft using petroleum jelly.
8. Carefully install the output shaft assembly in the case to
prevent damage to the sealing rings.
Y220_3A2980
BTRA 4 AUTO TRANSMISSION
REXTON SM - 2004.4