Removing The Device; Powering Off An Ex4600 Switch - Juniper EX4600 Series Hardware Manual

CHAPTER 19

Removing the Device

Powering Off an EX4600 Switch

Copyright © 2014, Juniper Networks, Inc.
Powering Off an EX4600 Switch on page 163
Removing an EX4600 Switch from a Rack or Cabinet on page 165
Before you power off an EX4600 switch:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge
(ESD) damage. See "Prevention of Electrostatic Discharge Damage" on page
Ensure that you do not need to forward traffic through the switch.
Ensure that you have the following parts and tools available to power off the switch:
An ESD grounding strap
An external management device such as a PC
An RJ-45 to DB-9 rollover cable to connect the external management device to the
console port
To power off an EX4600 switch:
Connect to the switch using one of the following methods:
1.
Connect a management device to the console (
instructions about connecting a management device to the console (
see "Connecting an EX Series Switch to a Management Console" on page
You can shut down the EX4600 switch from a management device on your
out-of-band management network. For instructions about connecting a
management device to the management (
EX4600 Switch to a Network for Out-of-Band Management" on page
Shut down Junos OS from the external management device by issuing the
2.
operational mode CLI command. This command shuts down the switch
system halt
gracefully and preserves system state information. A message appears on the console,
confirming that the operating system has halted.
You see the following output (or something similar, depending on the hardware being
shut down) after entering the command:
) port on a EX4600 switch. For
CON
or ) port, see "Connecting an
CO C1
120.
) port,
CON
153.
155.
request
163