Avaya S8700 Maintenance Manual page 127

ATM Tips
In this example the errors that have ATM-NTWK for Name and 1 for Data
indicate an error returned to the TN230X from the ATM network. In this
case, Type indicates the cause code returned by the ATM network (see
Table 4-6 on page
and 3) are reported from the ATM network. For more information about
these cause codes and repair information see
Error)'' on page
Table 4-6. Observed Cause Codes
Cause
Code Definition
3 No route to destination
31 Normal, unspecified
41 Temporary failure
47 Resources unavailable,
unspecified
63 Service or option unavailable,
unspecified
ATM Call Control
Are ATM signaling connections being setup to A500 Call Control?
Enter show switch circuit table on the A500 console.
screen output.
555-233-143
4-53). In the previous example, two cause codes (41
8-232.
Observed Cause
The ATM addresses administered in the ATM switch
(show signaling routes or show signaling esi) or in
S8700 Multi-Connect (display atm pnc) are incorrect.
This is a normal return.
This "try again later" cause code has been observed
when the source of the problem is on another port (for
example, a routing problem on another port that
displays cause code 3).
S8700 Multi-Connect call volume is too high for the
available resources in the ATM network.
S8700 Multi-Connect call volume is too high for the
available resources in the ATM network.
''ATM-NTWK (ATM Network
Figure 4-33 shows the
Issue 1 May 2002 4-53