Rep 8.2.3.5 Actuator (Act) Cover Assembly - Xerox DocuPrint N24 Service Manual

REP 8.2.3.5 Actuator (ACT) Cover Assembly

Parts List on PL 8.2.2.3
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove Mailbox Left Cover Assembly (REP 8.2.3.1).
3 Remove the Mailbox Front Cover Assembly (REP 8.2.3.2).
4 Remove the Mailbox Rear Cover Assembly (REP 8.2.3.3).
5 Remove the Mailbox Top Cover Assembly (REP 8.2.3.4).
6 Disconnect the P/J from the BIN 1 Jam Sensor, and pull the wire harness free of the ACT Cover
(Figure 8.2.3.5a).
7
Remove the three screws securing the ACT Cover Assembly to the Mailbox, and remove the ACT Cover
(Figure 8.2.3.5a).
Replacement
1 Position the ACT Cover Assembly over the top of the Mailbox.
2 Reinstall The ACT Cover Assembly onto the Mailbox.
3 Reinstall the wire harness under the wire clips located on the side of the ACT Cover and
reconnect the BIN 1 Jam Sensor.
4 Reinstall the ACT Cover Assembly.
5 Reinstall the Top Cover.
6 Reinstall the Rear Cover.
7 Reinstall the Front Cover.
DocuPrint N24, N32 and N40 Service Manual
Figure 8.2.3.5a. ACT Cover Assembly.
3/99
8-87 Options