Rep 8.5.3.80 Stapler Transport Motor - Xerox DocuPrint N24 Service Manual

REP 8.5.3.80 Stapler Transport Motor

Parts List on PL 8.5.2.17
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Roll the Finisher away from the printer until it stops.
3 Remove the Upper Rear Cover (REP 8.5.3.5).
4 Disconnect J886 (Figure 8.5.3.80a).
5 Remove the two screws securing the Stapler Transport Motor to the Motor Bracket, and remove
the Motor (Figure 8.5.3.80a).
6 Remove the Stapler Transport Motor Drive Belt (Figure 8.5.3.80a).
4
Replacement
1 Insert the Motor shaft through the cutout in the Motor Bracket.
2 Slip the Stapler Motor Drive Belt over the shaft gear. Use two screws to secure the Motor to the
Bracket.
3 Reconnect J886.
4 Reinstall the Upper Rear Cover.
5 Reconnect the Finisher to the Printer.
DocuPrint N24, N32 and N40 Service Manual
Figure 8.5.3.80a. Stapler Transport Motor.
5
3/99
8-441
6
5
SER800XA.PCX
Options