Operating Instructions; Model 1 - Dedicated Micr Printer; Model 2 - Dual Mode Micr/Non-Micr Printer - Xerox DocuPrint N24 Service Manual

8.6.5.4 Operating Instructions

8.6.5.4.1 Model 1 - Dedicated MICR Printer

This printer only functions when an ACOM MICR Toner Cartridge is installed!
Non-MICR or regular toner cartridges, including the XEROX EP Cartridge, will not operate in this model.
The MICR toner sensor inside the printer will detect if a Non-ACOM supplied MICR toner cartridge has
been installed. When doing so, the printer will stop the print cycle and the printer's Control Panel LCD
will display... LASER FAILURE, POWER ON/OFF. When this error message appears, the printer's
power must be reset (turned off & on) in order to clear the error. After the printer's power has been reset,
install an ACOM supplied MICR toner cartridge to continue printing.
CAUTION Any data, fonts, signatures, logos, forms, or macros downloaded to the printer prior
to getting this error message will be lost! Since the printer's power must be reset,
the printer's memory is cleared of any information. Once the printer's LCD displays
"READY", you must first download your fonts to the printer before restarting your
print job again. If you are using an ACOM SECURE-A-FONT Module, the PCMCIA
card must be removed and reinserted into the reader. This will download the stored
data from the PCMCIA card to the printer's memory.
NOTE: If your printer's Control Panel LCD displays the LASER FAILURE, POWER ON/OFF error
message after installing an ACOM supplied MICR toner cartridge, please call ACOM TECH
SUPPORT AT 1-800-217-ACOM (2266) for assistance.
8.6.5.4.2 Model 2 – Dual Mode MICR/Non-MICR Printer
This printer will only function when an ACOM supplied MICR or NON-MICR toner cartridge is installed!
This is a dual function printer, but you can only print MICR documents when a MICR cartridge is
installed.
This printer can be used for both MICR and Non-MICR printing requirements. The printer comes
equipped with two toner sensors, and ACOM's MICR Keylock installed. The Model 2 printer functions
quite the same as the Model 1 printer, with the only differences being that it has a Non-MICR toner
sensor and a MICR Keylock installed.
The position of the MICR Keylock determines the mode of the printer. The mode of the printer must
correspond to the installed toner cartridge in order for the printer to operate. For example; if the Keylock
is in the MICR OFF Mode ("12" & "6" O'clock position), the printer will only function if an ACOM supplied
NON-MICR toner cartridge is installed into the printer. If the Keylock is in the MICR ON Mode ("9" & "3"
O'clock position), the printer will only function if an ACOM supplied MICR toner cartridge is installed into
the printer. When in the MICR ON mode or "9" & "3" O'clock position, the actual key can not be removed
from the MICR Keylock. The key can only be removed when in the MICR OFF mode or in the "12" & "6"
O'clock position.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-581 Options