Rep 4.10.9 System Controller Interface Pwb - Xerox DocuPrint N24 Service Manual

REP 4.10.9 System Controller Interface
PWB
Parts List on PL 11.3
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Fuser Full Cover (REP 4.1.1).
3 Remove the Top Cover Assembly (REP 4.1.2).
4 Remove the System Controller PWB (REP 4.10.7)
5 Remove the System Controller PWB Cover (REP 4.10.8).
6 Disconnect the four connectors from the System Controller Interface PWB (Figure 4.10.9a).
7 Disconnect the video cable from the System Controller Interface PWB (Figure 4.10.9a).
8 Remove the two 7mm nuts from J423 (Figure 4.10.9a).
9 Remove the four screws securing the System Controller Interface PWB to the System Controller
PWB Box (Figure 4.10.9a).
10 Lift the System Controller Interface PWB out of the System Controller PWB Box.
DocuPrint N24, N32, N40, N3225, and N4025
Figure 4.10.9a. System Controller Interface PWB.
2/2000
4-95
CAUTION
These components are susceptible
to electrostatic discharge. Observe
all ESD procedures to avoid
damage.
Repair Procedures