Paper Output Devices & Support Paper Specifications; Face Down Bin (Standard); Offset Unit (Standard) - Xerox DocuPrint N24 Service Manual

Network laser printer
Hide thumbs Also See for DocuPrint N24:
Table of Contents

Advertisement

2.12 Paper Output Devices & Support Paper Specifications
The printer uses the following paper output/paper size combinations:

Face Down Bin (Standard)

Offset Unit (Standard)

Duplex Mode (Option)
Face Up Bin (Standard)
Mailbox (Option)
Finisher (Option)
2.12.1 Face Down Bin (Standard)
Standard output bin for the DocuPrint N24/N32/N40/N3225/N4025. Paper is transported out of the printer face
down onto the printer Top Cover. This Bin holds up to 500 sheets of 20 lb (80gsm)paper, and comes equipped with
Full Stack detection. When the Finisher is installed on the printer, the maximum paper stack in the Face Down Bin
is reduced to 300, and the Finisher monitors Full Stack detection.
2.12.2 Offset Unit (Standard)
The Offset Unit is attached above the Fuser on the printer base engine. Each sheet of paper is transported out of
the printer, offset 10mm from the previous job, then placed in the Face Down Bin. Paper size supported by the Off-
set Unit:
Printer Specifications
Letter LEF - 8.5" x 11" (216mm x 279mm)
Legal 13" SEF - 8.5" x 13" (216mm x 330mm)
Legal 14" SEF- 8.5" x 14" (216mm x 356mm)
A4 LEF - 8.3" x 11.7" (210mm x 297mm)
Ledger SEF - 11.7" x 17" (297mm x 432mm)
A3 SEF - 11.7" x 16.5" (297mm x 420mm)
Executive LEF - 7.25" x 10.5" (184.2mm x 266.7mm)
Paper
2/2000
2-20
DocuPrint N24, N32, N40, N3225, and N4025

Advertisement

Table of Contents
loading

Table of Contents