Rep 8.5.3.49 Tamper Motor - Xerox DocuPrint N24 Service Manual

REP 8.5.3.49 Tamper Motor

Parts List on PL 8.5.2.11
Removal
1 Enter Diagnostic Mode 5.4.5 (Running Service Output Test) Finisher ELVR CCW to lower the
Stacker Elevator so the Bottom Bin is at the lowest possible position.
2 Switch off the printer power and disconnect the AC Power Cord.
3 Disconnect the Finisher from the Printer (REP 8.5.3.1).
4 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3)
5 Remove the Upper Rear Cover (REP 8.5.3.5).
6 Remove the Transport Assembly (REP 8.5.3.11).
7 Remove the Upper Left Cover (REP 8.5.3.12).
8 Remove the four screws securing the Tie Plate to the Finisher frame (Figure 8.5.3.49a). Remove
the Tie Plate.
9 Remove the Top Bin Assembly (REP 8.5.3.38).
10 Remove the four screws securing the Eject Roll Chute to the Finisher frame (Figure 8.5.3.49a).
Remove the Chute.
11 Disconnect J867 and remove the Tamper Motor Wiring Harness from all cable clips (Figure
8.5.3.49b).
12 Accessing the rear of the Tamper Motor, remove the two screws that secure the Motor to the
Compiler Bin (Figure 8.5.3.49b).
13 Slip the Tamper Motor Drive Belt off of the Motor Pulley (Figure 8.5.3.49b), and remove the
Motor.
Options
Figure 8.5.3.49a. Tie Plate and Eject Roll Chute.
2/2000
8-388 DocuPrint N24, N32, N40, N3225, and N4025