Rep 4.3.2 Mbf Tray Assembly - Xerox DocuPrint N24 Service Manual

REP 4.3.2 MBF Tray Assembly

Parts List on PL 4.1
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Duplex Unit, if one is installed.
3 Remove the MBF Assembly (REP 4.3.1).
4 Remove the two screws securing the MBF Top Cover to the MBF Assembly, and remove the Top
Cover (Figure 4.3.2a).
5 Disconnect P/J107 that runs to the Tray Assembly (Figure 4.3.2b).
6 Remove the Tray Harness from the cable clamp and pull the connector through the MBF frame.
7 Release the Tray Spring that is attached to the left side of the Tray (Figure 4.3.2b).
8 Push on the Front Support as you slightly bow the Tray, and release the pivot hole on the side of
the Tray from the metal shaft on the Front Support (Figure 4.3.2b).
9 Remove the MBF Tray Assembly.
Repair Procedures
Figure 4.3.2a. MBF Assembly Cover.
Figure 4.3.2b. MBF Tray Assembly.
2/2000
4-42 DocuPrint N24, N32, N40, N3225 and N4025