Rep 8.1.3.6 Duplex Wait Clutch - Xerox DocuPrint N24 Service Manual

REP 8.1.3.6 Duplex Wait Clutch

Parts List on PL 8.1.2.2
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Duplex Rear Cover (REP 8.1.3.3).
3 Disconnect P/J224 (Wait Clutch) from the Duplex PWB (Figure 8.1.3.6a).
4 Remove the E-ring from the end of the Wait Clutch shaft (Figure 8.1.3.6a).
5 Push up on the shaft latch as you slide the Clutch off the shaft.
Replacement
1 Position the Wait Clutch so the notch in the Clutch lines up with the tab on the Duplex frame.
2 Slide the Clutch onto the shaft. The shaft latch snaps the Clutch into place on the shaft.
3 Use an E-ring to secure the Clutch to the shaft.
4 Reconnect P/J224 to the Duplex PWB.
5 Reinstall the Duplex Rear Cover.
Options
Figure 8.1.3.6a. Duplex Wait Clutch
3/99
8-32 DocuPrint N24, N32 and N40 Service Manual