Rep 8.5.3.50 Tamper Home Sensor - Xerox DocuPrint N24 Service Manual

Network laser printer
Hide thumbs Also See for DocuPrint N24:
Table of Contents

Advertisement

REP 8.5.3.50 Tamper Home Sensor

Parts List on PL 8.5.2.11
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Disconnect the Finisher from the Printer (REP 8.5.3.1).
3 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3)
4 Remove the Upper Rear Cover (REP 8.5.3.5).
5 Remove the Transport Assembly (REP 8.5.3.11).
6 Remove the Upper Left Cover (REP 8.5.3.12).
7 Remove the four screws securing the Tie Plate to the Finisher frame (Figure 8.5.3.50a). Remove
the Tie Plate.
8 Loosen the screw securing the Tamper Home Sensor Bracket to the Compiler Bin, and remove
the Bracket along with the Tamper Home Sensor (Figure 8.5.3.50b).
9 Disconnect P839 from the Sensor (Figure 8.5.3.50b).
10 Press in and release the Sensor latches that are securing the Sensor the Sensor to the Bracket,
and remove the Sensor (Figure 8.5.3.50b).
Options
Figure 8.5.3.50a. Tie Plate.
3/99
8-390
DocuPrint N24, N32 and N40 Service Manual

Advertisement

Table of Contents
loading

Table of Contents