Xerox DocuPrint N24 Service Manual page 883

Replacement
1 Reinstall the Eject Clamp Offset Motor into the Eject Bracket Assembly, and use three screws to
secure the Motor.
2 Reinstall the two Idler Gears.
3 Reinstall the Drive Gear, and use an E ring to secure the Gear.
4 Reinstall the Offset Cam Assembly, with the Actuator toward the inside wall of the Eject Bracket
Assembly, into the Assembly.
5 Reinstall the bearings to both ends of the Offset Cam Assembly Shaft.
6 Reinstall an E ring to short end of the Offset Cam Assembly Shaft.
7 Reinstall the One Way Gear to the end of Offset Cam Assembly Shaft, and use an E ring to
secure the Gear to the Shaft.
8 Reinstall the Eject Bracket Assembly.
9 Reinstall the Offset Home Sensor.
10 Reinstall the Eject Clamp Sensor.
11 Reinstall the Upper Rear Cover.
12 Reconnect the Finisher to the Printer.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-445 Options