Rap 7.5 Paper Jam / Clear Area A (C2-3) - Xerox DocuPrint N24 Service Manual

RAP 7.5 Paper Jam / Clear Area A (C2-3)

1 Inspect the paper that is loaded in the paper tray. The paper loaded in the tray is smooth (not
wrinkled) and undamaged.
Y N
|
Replace the paper with new paper.
2 Inspect the paper path for paper scraps or foreign objects that could cause a paper jam. The
paper path is clear.
Y N
|
Clear the paper path.
3 Enter Diagnostic Mode - 5.4.5 Running a Service Output Test, Main Motor On/Off to start the
Main Motor. Open the Tray 2 Transport Cover. The Take Away Rolls rotate when you run the
Main Motor.
Y N
|
Replace Tray 2 Take Away Rolls (REP 4.2.7).
4 Enter Diagnostic Mode - 5.4.6 Running a Service Sensor (H/L) Input Test, Regi Sensor Detect
(Select Roll 2). Insert a sheet of paper into the Registration Sensor and press [4], then remove
the sheet of paper and press [4]. The Control Panel LCD displays H when paper is inserted into
the Registration Sensor, and displays L when the paper is removed.
Y N
|
Check wiring between P/J 459 and P/J 100 (6.3.14). If OK, replace the Registration Sensor
(REP 4.4.2).
5 Replace the Printer Engine Controller PWB (REP 4.10.6).
DocuPrint N24, N32 and N40 Service Manual
3/99
7-11 Repair Analysis Procedures (RAP)